Hydrogen Fuel HHO Cell High Amperage Testing Method (Shunt)

This is our homemade shunt for running higher amperage tests in combination with our hho-cell. Everything here can be store bought at Home-Depot, Lowes, or just about any hardware store.

It is a hacksaw blade being used as a ‘shunt’ to measure amperage through our hho-cell. This in-fact will give us the ability to measure much higher amperage through our sensitive test equipment. The shape of the blade also gives great advantages for cooling with a heavier load.

Multimeter Reading:

About 0.1V at 5A for sensing

You might have to calibrate your own figures based on different style and/or manufactured hacksaw blades.

Best method for calibration would be to take something of known Wattage. We used a 12V-50Watt Bulb, and used that for verifying the output in millivolts. Works really well if you ask me. Hope this helps someone out there make their tests that much more viable.

Thanks for viewing my videos..

Regards, sirHOAX

Ultimate Hydrogen Generator “Hydro Hybrid” 20 Cell HHO Gas Saver


Hydrogen HHO Generator Ebook Get It Here
Does not get hot, no sludge, over 1 LPM, 20 cells 316 stainless steel plates perfectly spaced. Toyota Camry just went from 28 MPG to 43 MPG!!! F250 16 to 24 MPG!

Hydrogen Fuel Cell HHO – Car Enclosure Install Nissan Altima

Water Fuel Cell Ebook Click Here

Here is the enclosure being made to be permanently installed in my 1998 Nissan Altima 2.4Liter Engine Compartment.

Took me a couple of hours to throw the parts together, just wanted to make sure everything was in tight so there was no room for vibration loosening things up.

Please take note of the placement of the HHO-Cell, right above the exhaust header. That is why if you also notice, we installed a galvanized heat shield right below the enclosure. Just to make sure this doesn’t become an issue when we try to calibrate our heat inside the hydrogen cell.

Regards, and Thanks for viewing my video..

–sirHOAX