25 thoughts on “April update and solution for hho generator”
Nichensays:
I just tried your winter electrolyte solution with the 3% concentrated Hydrogen Peroxide, and it´s just fantastic!!! Thank you SO MUCH for helping me out. If I was the king of Sweden I would easily give you the Nobel Prize, no doubt about it. Again, THANK YOU SO MUCH.
Nichensays:
What is the concentration of your Hydrogen Peroxide bottle? 3%?
AlmostHydrogensays:
sodium hydroxide in the concentrations used with hydroxy cells is minimal.
I use 2 teaspoons of NaOH w/ 2 liters of distilled water. I run my booster 11.3V, about 16 amps when cold (20 amps when cell is warm). Never a problem w/ burns, clothing, etc. IOW its a small amount; so if u use baking soda fine, but dont make it sound like naoh is the plague.
The cool thing is that our cells can use a variety of additives.
Keep up the good work.
🙂
bluejacker010says:
2/2 Microscopic metallic particles flow from the positive plate(s) to the negative plate(s) this is a basic fact in every electrolytic process. some of these particles are dangerous and can cause cancer. See this youtube video for more info:
Myth or Truth, is Hexavalent Chromium in the Electrolyte
so Wear rubber gloves and dispose used electrolyte properly (dont flush it down the drain) and you’ll be safe
bluejacker010says:
1/2 Hi, I watched your video and saw that you are trying to use non toxic and environmental friendly stuff to make the electrolyte for your cell. But did You Know that even with non toxic ingredients in the electrolyte, your making Hexavalent Chromium in the Electrolyses process. The hexavalent chromium comes from the metal in the cell plates.
dire67says:
by winter mix, do you mean it resists freezing?
dire67says:
I got the brown substance you mentioned when I used salt, and never with baking soda. In fact, the plates I used with salt had the brown gunk on it. When I switched to baking soda, it cleaned it right off.
studstud1says:
Forgot to mention. I tried the mixture with 1 tablespoon and 2 tablespoons. My jar gets VERY hot!
studstud1says:
So let me tell you my problem. After I installed my fuel cell just like you recommended. I am getting LESS gas mileage. What am I doing wrong? I do get hho when tested in a cup of water. But when plugged into car I get Less? Please help!
sm0ky40says:
Try this mix…
3 tablespoons baking soda
2 oz white vinegar
3 cups rain water
1 cup Rubbing Alcohol
2 caps Hydrogen Peroxide
although this is a winter mix, it does produce good amounts of gas.
watch?v=ZcMww00to5w
studstud1says:
I dont understand. Is it CUPS or CAPS for the alcohol?? Sumbich says caps and RickM1953 says caps and cups in both of his posts. Can someone please clarify and give the correct mix? Thank You.
GonaMarvelsays:
Haven’t heard from you for a while Sm0ky. We like all your pointers and detailed explanations; very helpful. How are your Saturn and Escort doing? Any news on mileage improvements? Hope to hear from you soon.
sumbichsays:
The actual ingredients are:
2 Tablespoons Baking Soda
4 oz Distilled White Vinegar (a shot glass = 2 oz)
2-3 Cups of Distilled Water
3 Caps Hydrogen Peroxide
3 Caps Rubbing Alcohol
–I’ve used this mix for mine, and it works great!!!!! Thanks sm0ky!!!!!
decalsbyjtsays:
Hey thanks for the info…
where did you get your small 12v pump?
thanks
rickypreachersays:
your solution mixture, do you mix with distilled water or vinegar after you cook it up or is this what you put in the generator by itself.
vison2createsays:
What’s the alcohol and peroxide for?
rodda49says:
G’day Smoky. thanks for all your technical stuff. Do you use the winter solution as is or do you use it as a base [or concentrate] and dilute it down? Is there a problem with the solution continuing to gas when the motor is turned off thus filling the manifold with an over supply of HHO?
RayBthesecondsays:
interesting concept.how does it performe and how have you tested it for its freeze point?
mrgwrench45says:
thank you Rick for your quick response. I apprecate it.
RickM1953says:
Sorry LOL the first one is correct..MY BAD
RickM1953says:
Correction….
HHO Electrolyte
Step 1: In a quart pot – Mix 2 table spoons Bake Soda with 2 oz. of Distilled White Vinegar. Stir well.
Step 2: Add 2-3 cups of warmed distilled water or Rain Water. Stir well to dissolve the Baking Soda.
Step 3: Add 2 caps of Hydrogen Peroxide — Stir
Step 4: Add 2 CAPS of Isopropyl Alcohol — BE CAREFUL!!!!
Optional: Add a drop or two of food color, color of your choice.
RickM1953says:
HHO Electrolyte
Step 1: In a quart pot – Mix 2 table spoons Bake Soda with 2 oz. of Distilled White Vinegar. Stir well.
Step 2: Add 2-3 cups of warmed distilled water or Rain Water. Stir well to dissolve the Baking Soda.
Step 3: Add 2 caps of Hydrogen Peroxide — Stir
Step 4: Add 2 cups of Isopropyl Alcohol — BE CAREFUL!!!!
Optional: Add a drop or two of food color, color of your choice.
mrgwrench45says:
hi Rick my name is Bill and i was wondering if you have found the answer to your question about the amount of the ingrediants in the solution
mrgwrench45says:
i,m sorry but i am new to this can anyone tell me where to find the answer to this question mrgwrench45
mike081283says:
dose the hho clean up the engein and the cat i would think so
I just tried your winter electrolyte solution with the 3% concentrated Hydrogen Peroxide, and it´s just fantastic!!! Thank you SO MUCH for helping me out. If I was the king of Sweden I would easily give you the Nobel Prize, no doubt about it. Again, THANK YOU SO MUCH.
What is the concentration of your Hydrogen Peroxide bottle? 3%?
sodium hydroxide in the concentrations used with hydroxy cells is minimal.
I use 2 teaspoons of NaOH w/ 2 liters of distilled water. I run my booster 11.3V, about 16 amps when cold (20 amps when cell is warm). Never a problem w/ burns, clothing, etc. IOW its a small amount; so if u use baking soda fine, but dont make it sound like naoh is the plague.
The cool thing is that our cells can use a variety of additives.
Keep up the good work.
🙂
2/2 Microscopic metallic particles flow from the positive plate(s) to the negative plate(s) this is a basic fact in every electrolytic process. some of these particles are dangerous and can cause cancer. See this youtube video for more info:
Myth or Truth, is Hexavalent Chromium in the Electrolyte
so Wear rubber gloves and dispose used electrolyte properly (dont flush it down the drain) and you’ll be safe
1/2 Hi, I watched your video and saw that you are trying to use non toxic and environmental friendly stuff to make the electrolyte for your cell. But did You Know that even with non toxic ingredients in the electrolyte, your making Hexavalent Chromium in the Electrolyses process. The hexavalent chromium comes from the metal in the cell plates.
by winter mix, do you mean it resists freezing?
I got the brown substance you mentioned when I used salt, and never with baking soda. In fact, the plates I used with salt had the brown gunk on it. When I switched to baking soda, it cleaned it right off.
Forgot to mention. I tried the mixture with 1 tablespoon and 2 tablespoons. My jar gets VERY hot!
So let me tell you my problem. After I installed my fuel cell just like you recommended. I am getting LESS gas mileage. What am I doing wrong? I do get hho when tested in a cup of water. But when plugged into car I get Less? Please help!
Try this mix…
3 tablespoons baking soda
2 oz white vinegar
3 cups rain water
1 cup Rubbing Alcohol
2 caps Hydrogen Peroxide
although this is a winter mix, it does produce good amounts of gas.
watch?v=ZcMww00to5w
I dont understand. Is it CUPS or CAPS for the alcohol?? Sumbich says caps and RickM1953 says caps and cups in both of his posts. Can someone please clarify and give the correct mix? Thank You.
Haven’t heard from you for a while Sm0ky. We like all your pointers and detailed explanations; very helpful. How are your Saturn and Escort doing? Any news on mileage improvements? Hope to hear from you soon.
The actual ingredients are:
2 Tablespoons Baking Soda
4 oz Distilled White Vinegar (a shot glass = 2 oz)
2-3 Cups of Distilled Water
3 Caps Hydrogen Peroxide
3 Caps Rubbing Alcohol
–I’ve used this mix for mine, and it works great!!!!! Thanks sm0ky!!!!!
Hey thanks for the info…
where did you get your small 12v pump?
thanks
your solution mixture, do you mix with distilled water or vinegar after you cook it up or is this what you put in the generator by itself.
What’s the alcohol and peroxide for?
G’day Smoky. thanks for all your technical stuff. Do you use the winter solution as is or do you use it as a base [or concentrate] and dilute it down? Is there a problem with the solution continuing to gas when the motor is turned off thus filling the manifold with an over supply of HHO?
interesting concept.how does it performe and how have you tested it for its freeze point?
thank you Rick for your quick response. I apprecate it.
Sorry LOL the first one is correct..MY BAD
Correction….
HHO Electrolyte
Step 1: In a quart pot – Mix 2 table spoons Bake Soda with 2 oz. of Distilled White Vinegar. Stir well.
Step 2: Add 2-3 cups of warmed distilled water or Rain Water. Stir well to dissolve the Baking Soda.
Step 3: Add 2 caps of Hydrogen Peroxide — Stir
Step 4: Add 2 CAPS of Isopropyl Alcohol — BE CAREFUL!!!!
Optional: Add a drop or two of food color, color of your choice.
HHO Electrolyte
Step 1: In a quart pot – Mix 2 table spoons Bake Soda with 2 oz. of Distilled White Vinegar. Stir well.
Step 2: Add 2-3 cups of warmed distilled water or Rain Water. Stir well to dissolve the Baking Soda.
Step 3: Add 2 caps of Hydrogen Peroxide — Stir
Step 4: Add 2 cups of Isopropyl Alcohol — BE CAREFUL!!!!
Optional: Add a drop or two of food color, color of your choice.
hi Rick my name is Bill and i was wondering if you have found the answer to your question about the amount of the ingrediants in the solution
i,m sorry but i am new to this can anyone tell me where to find the answer to this question mrgwrench45
dose the hho clean up the engein and the cat i would think so