Cell was made from 12 stainless steel plates, baking soda was added to water. Disconnected rubber hose from intake manifold, drilled a hole in the intake manifold rubber hose(just after the airfilter), Put hydrogen hose into manifold. Hooked HHO wires up to car battery(just held them there, to test). 14guage, 20 amp wire, also a 40amp fuse was used on the hydrogen generator. After I hooked it up, it sounded fine. I didnt proceed to hook the generator up. I test drove the car without the HHO and immediately at 3000 rpms the car would sputter and wouldnt go over 3000rpms. I tried to reset the computer by unhooking the neg. battery terminal, I checked the O2 sensors, they looked fine. I dont think there is a leak in the vacuum but will be getting carb cleaner to check. Thanks for your help. -Jacqueline
Vacuum
John Kanzius’ Water Fuel Cell
John Kanzius Water Fuel Cell/Cancer Treatment
John Kanzius, while researching a way to treat cancer & other diseases, stumbled a across the same principal as Stan Meyer’s Water Fuel Cell. Unlike Meyer’s device, which uses submerged stainless steel electrodes in a common feed stock of water, Mr. Kanzius’ device doesn’t make contact with the water — it pulses relatively low energy across an area, such as the human body, which is made of mostly water, or across a test tube of salt water. The salt in the water helps catalyze the process (by increasing the conductivity of the water).
The device can also be looked at as a water capacitor. Water is the feed stock and the pulses (electrical & radio waves) disassociate the hydrogen & oxygen atoms by magnetically stretching apart the atoms through constant magnetic excitation. Parallel plates, or circular or spiral electrodes or transducers all have the ability to tap energy from the quantum flux field. When these devices are used with water such as John Kanzius’ device, the energy from the quantum flux field is tapped into, then trapped by the water, turning it into a charged gas of diatomic & monatomic hydrogen & oxygen atoms, in a mixture of hydrated electrons. When combusted, the plasma implosion/explosion forms back into pure water. The plasma gas is a stoichiometric blend that is perfect for combustion applications.
This device behaves very similarly to Stan Meyer’s Electron Extraction Circuit (which uses lasers), and is the key electronic mechanism which makes his device a true water fuel cell, because the EEC produces an electrical current. The transducers, which face each other, vibrate a high radio frequency (in the ~20KHZ-200KHZ region). The power is low enough not to cause bodily harm, so is perhaps less than 200 watts. Since there is little if any heat build up between the working transducers, the excess energy exhibited with the Brown’s gas can not be traced, thus pointing to the quantum vacuum as the source of free energy.
John Kanzius’ device may be the same explanation for the technology behind the Segway inventor, Dean Kaman’s newest invention, the WATER PURIFIER.
http://www.time.com/time/2003/inventions/invwater.html
Although John Kanzius’ device has made recent news including on the Colbert Report, it must also be noted that this technology has been around the medical pioneer field for a bit longer. To see a similar technology for treating cancer using microwaves, please see the Sterling Allan PES interview with Joel Fallik (on 06-07).
http://pesn.com/Radio/Free_Energy_Now/
For those who are developing their own clean energy and zero-point energy systems, or for those who would like to be involved with this promotion, please visit:
http://www.theorionproject.org