100 WATTS TORCH HHO HYDROGEN GENERATOR FLAME

The Best HHO Fuel Cell Generator Conversion Kit Click Here
Setup Primary and secondary electrode, secondary 13x diameter 52mm, bottom is Primary electrode with small 5 rectan.
plates 20x45mm to push the gas of the secondary electrode out of the plates.
power 12v 8amp

15 thoughts on “100 WATTS TORCH HHO HYDROGEN GENERATOR FLAME

  1. Sumermagor says:

    Ayugen 1500- ayugen 2000 = very expensive,
    input 220volt output 150-200volts,
    i can do that and not for $6900.00
    i can do that machine system for $100 much cheaper isn’t it?
    DIY

  2. ballscrewpro says:

    The trick is the nozzle hole diameter.
    The hole diameter is 0.5mm (.020″ 20 thous)
    a must,use steel wool for flash back arrestor.
    The fire is small, no light and not visible,

  3. freedomorelse says:

    If anyone is interested in seeing an Aquygen 1500 Generator in action and you live near Ashland, KY 41101 give me a call for an appointment. 606 547 5883 Ask for Matt.

    Thanks

  4. bartlettstaffer says:

    I like it…its cool. are you using just a 12v 7A DC voltage or are you pulsing it with a Meyer-type circuit?

    Thanks

  5. Tentoestwice says:

    First rate craftsmanship!

    Please elaborate… are you using a Lawton circuit? Have you conditioned your tubes? What is the hydroxy gas output at the operating conditions of your van.

  6. ballscrewpro says:

    my philosophy is to use tap or distill water,
    cell respond to 2.0amp 12v, In order to build up the pressure to make flame i add some KOH (potassium hydroxide) to bring up the current to 7 amp. This flat plate cell surface area is approx. 70 sq.inches that consume 2 amp on tap water & work out to 1 sq. inch =.03amp. Actually the water is brown color, Looks red color due2wire in front. My test results shown that flat plate hydrogen production is lesser than tube setup.

Leave a Reply

Your email address will not be published. Required fields are marked *